I don't see any general problems with these work units. The pass rate is high as expected, ~98%. They have been running for a while now without any changes. You might want to try to reset and detach the project on your client and then reattach.

i did the above, and guess what, i have another failed abrelax WU, this cant be coincidence?

and another 1, result id: 110480349
2 out of 5 errors.

Hi Luuklag

I guess it could be a corrupt file, although you say you've detached/reattached?
I take it the machine is overclocked (from the benchmarks which are a fair bit higher than one of my remote crunchers)? I know the Venice core's are pretty good OCers but is there a chance it's being pushed too far/too little voltage/too hot?

Otherwise dunno - it's quite a strange problem...

---

Hi Luuklag

I guess it could be a corrupt file, although you say you've detached/reattached?
I take it the machine is overclocked (from the benchmarks which are a fair bit higher than one of my remote crunchers)? I know the Venice core's are pretty good OCers but is there a chance it's being pushed too far/too little voltage/too hot?

Otherwise dunno - it's quite a strange problem...

my pc is complete stock, but now these WU's are comming along quite good, so i guess that file was just 1 corrupt file, and not a crunching problem, thx anyways.

I don't see any general problems with these work units. The pass rate is high as expected, ~98%. They have been running for a while now without any changes. You might want to try to reset and detach the project on your client and then reattach.

well i did this, and it went good for the time beeing, but now again, 3 failed WU's in a row... ? anyone got a clue, or just de attach reattach reset etc. again?

My Results list.

[edit]
I just pause the abrelax WU's and trying a nother kind of wu now, to c if its in the abrelax WU's.